WATER STOP WATERPROOFING

Water retention insulation coating; silicone modified, styren acrylic copolymer emulsion based, water-based, matte appearance, interior and exterior water leakage prevention insulation paint.

Areas of use: Concrete, plaster, chipboard, drywall wall and plaster are applied as a protective product for the purpose of waterproofing on surfaces.

Applicable surfaces: Applied to the primed surfaces of concrete, plaster, chipboard, drywall and plaster treated floors

PHYSICAL FIXTURES:

Colors: White and desired colors.

pH Value: 8 – 9.

Last view:Matte.

Theoretical coating value: Depending on the condition of the surface to which it is applied, it is approximately 7 m2- 10 m2 / L on a single floor.

Flash point: Non-flammable and flammable.

Specific gravity: Approximately 1,40 – 1,50 gr/cm3.

Drying time: Approximately 4-6 hours at 20 ºC.

Viscosity:No Measurement.140 KU and above (at 25 ºC)

Application Methods: It is applied with brush or roller.

Thinning:It is diluted with clean water. (50% for the first floor, 30% for the second floor, 15% for the third floor, estimated enough for the application vehicle to work comfortably.)

Cleaning of application means: with clean water.

Required dry film thickness: Approximately 150 – 180 microns. (on three floors)

Required wet film thickness: Approximately 100 microns. (on one floor)

Standby time between two times: 8 hours.

Full drying time: 24 hours.

Important warning: The values given above apply to environments with a relative humidity of 25 ºC and less than 70 %.

Packaging types: in packages of 3.5 kg, 10 kg, 20 kg.

Shelf Life: Two years, provided that it is in unopened packaging and kept in a cool place.

Storage and Transportation: In a well-ventilated environment, in a cool place and in such a way that there is no direct sunlight.

  • S 2 Keep out of the reach of children.
  • S 3/7/9 Store the box in a well-enclosed place, in a cool and well-ventilated place.
  • S 16 Keep away from igniting sources.
  • S 23 Do not inhale Gas/Smoke/Vapor/Aerosol.
  • S 24/25 Avoid eye and skin contact.
  • S 26 In case of contact with eyes, immediately block with plenty of water, immediately consult a doctor.
  • S 28 Upon contact with the skin, immediately wash off with plenty of water.
  • S 29 Do not empty into the sewer.
  • S 37 Use appropriate protective gloves.
  • S 46 If swallowed, consult a doctor immediately, show the packaging or label.
  • S 51 Use only in well-ventilated areas.
  • During the application of processes such as sandblasting and burning on painted surfaces, harmful dust and / or smoke may be released, work in well-ventilated places.
  • Use appropriate personal protective equipment when necessary.
  • Upon request, a Safety Data Sheet (MSDS) and/or Technical Bulletin may be requested for detailed information.